IEEE SEM Chapter IV MTT-S Distinguished Lecture (REMOTE): Low Phase Noise Signal Generation Utilising Oscillators, Resonators & Filters and Atomic Clocks
Jeremy Everard
Professor of Electronics, University of York, Canada
Monday March 16th, 2020
Abstract: This talk will initially discuss the theory and design of a wide variety of oscillators offering the very best performance. Typically, this is achieved by splitting the oscillator design into its component parts and developing new amplifiers, resonators and phase shifters which offer high Q, high power handling and low thermal and transposed flicker noise. Key features of oscillators offering the lowest phase noise available will be shown, for example: a 1.25GHz DRO produces -173dBc/Hz at 10kHz offset and a noise floor of -186dB and a 10 MHz crystal oscillator shows -123dBc/Hz at 1Hz and -149 at 10Hz. New compact atomic clocks with ultra-low phase noise microwave synthesiser chains (with micro Hz resolution) will also be briefly described to demonstrate how the long-term stability can be improved.
New printed resonators (and thereby filters) demonstrate Qs exceeding 540 at 5GHz on PCBs and > 80 at 21GHz on GaAs MMICs. These resonators produce near zero radiation loss and therefore require no screening. L band 3D printed resonators demonstrate high Q (> 200) by selecting the standing wave pattern to ensure zero current through the via-hole and new ultra-compact versions (4mm x 4mm) have been developed for use inside or underneath the package. Alumina based resonators demonstrating Qs >200,000 at X band have also been produced. Tuneable versions (1%) have recently been developed.
Dr. Everard presented the first course on oscillators including a lab class at the IEEE International Microwave Symposium in Boston in ‘09 and then again in 2010 and 2011. A battery powered lab kit offering 5 experiments with full theoretical and simulation support was provided. The kit also produced the state-of-the-art performance with flicker noise corners around 200Hz. The methodology behind this course will be described. Theory and 5 experiments on the same day was part of the reason for success.
The next generation of oscillators will offer orders of magnitude improvement in performance. Our current attempts to do this will be described.
BIOGRAPHY: Jeremy Everard obtained his degrees from King’s College London and the University of Cambridge, UK in 1976 and 1983 respectively. He worked for six years in industry at GEC Marconi Research Laboratories, M/A-Com and Philips Research Laboratories on Radio and Microwave circuit design. At Philips he ran the Radio Transmitter Project Group. He then taught at King's College London for nine years and became full Professor of Electronics at the University of York in September 1993. He has taught analogue IC design, switched mode PSU & Class D audio amplifier design, optoelectronics, filter design, Electromagnetism and RF & microwave circuit design. In September 2007, he was awarded a five-year research chair in Low Phase Noise Signal Generation sponsored by BAE Systems and the Royal Academy of Engineering.
In the RF/Microwave area his research interests include: The theory and design of low noise oscillators; flicker noise measurement and reduction high efficiency broadband amplifiers; high Q printed filters with low radiation loss and broadband negative group delay circuits. In Opto-electronics, research includes: All optical self-routing switches which route data-modulated laser beams according to the destination address encoded within the data signal, ultra-fast 3-wave opto-electronic detectors and mixers and distributed fibre optic temperature sensors. Recent research involves the development of atomic clocks using coherent population trapping and ultra-low phase noise microwave flywheel oscillator synthesiser chains with micro Hz resolution. He has published a book on 'Fundamentals of RF Circuit Design with Low Noise Oscillators’ (Wiley).
Date and Time
Location
Hosts
Registration
- Date: 16 Mar 2020
- Time: 05:00 PM to 06:30 PM
- All times are (GMT-05:00) US/Eastern
-
Add Event to Calendar
- Remote Event, Michigan
- United States
- Contact Event Host
-
Dr. Najme Ebrahimi
- Co-sponsored by University of Michigan's ECE Radiation Laboratory and IEEE Southeastern MI Trident Chapter IV
Speakers
Prof. Jeremy Everard of University of York
Low Phase Noise Signal Generation Utilising Oscillators, Resonators & Filters and Atomic Clocks
Abstarct: This talk will initially discuss the theory and design of a wide variety of oscillators offering the very best performance. Typically, this is achieved by splitting the oscillator design into its component parts and developing new amplifiers, resonators and phase shifters which offer high Q, high power handling and low thermal and transposed flicker noise. Key features of oscillators offering the lowest phase noise available will be shown, for example: a 1.25GHz DRO produces -173dBc/Hz at 10kHz offset and a noise floor of -186dB and a 10 MHz crystal oscillator shows -123dBc/Hz at 1Hz and -149 at 10Hz. New compact atomic clocks with ultra-low phase noise microwave synthesiser chains (with micro Hz resolution) will also be briefly described to demonstrate how the long-term stability can be improved.
New printed resonators (and thereby filters) demonstrate Qs exceeding 540 at 5GHz on PCBs and > 80 at 21GHz on GaAs MMICs. These resonators produce near zero radiation loss and therefore require no screening. L band 3D printed resonators demonstrate high Q (> 200) by selecting the standing wave pattern to ensure zero current through the via-hole and new ultra-compact versions (4mm x 4mm) have been developed for use inside or underneath the package. Alumina based resonators demonstrating Qs >200,000 at X band have also been produced. Tuneable versions (1%) have recently been developed.
Dr. Everard presented the first course on oscillators including a lab class at the IEEE International Microwave Symposium in Boston in ‘09 and then again in 2010 and 2011. A battery powered lab kit offering 5 experiments with full theoretical and simulation support was provided. The kit also produced the state-of-the-art performance with flicker noise corners around 200Hz. The methodology behind this course will be described. Theory and 5 experiments on the same day was part of the reason for success.
The next generation of oscillators will offer orders of magnitude improvement in performance. Our current attempts to do this will be described.
Biography:
Jeremy Everard obtained his degrees from King’s College London and the University of Cambridge, UK in 1976 and 1983 respectively. He worked for six years in industry at GEC Marconi Research Laboratories, M/A-Com and Philips Research Laboratories on Radio and Microwave circuit design. At Philips he ran the Radio Transmitter Project Group. He then taught at King's College London for nine years and became full Professor of Electronics at the University of York in September 1993. He has taught analogue IC design, switched mode PSU & Class D audio amplifier design, optoelectronics, filter design, Electromagnetism and RF & microwave circuit design. In September 2007, he was awarded a five-year research chair in Low Phase Noise Signal Generation sponsored by BAE Systems and the Royal Academy of Engineering.
In the RF/Microwave area his research interests include: The theory and design of low noise oscillators; flicker noise measurement and reduction high efficiency broadband amplifiers; high Q printed filters with low radiation loss and broadband negative group delay circuits. In Opto-electronics, research includes: All optical self-routing switches which route data-modulated laser beams according to the destination address encoded within the data signal, ultra-fast 3-wave opto-electronic detectors and mixers and distributed fibre optic temperature sensors. Recent research involves the development of atomic clocks using coherent population trapping and ultra-low phase noise microwave flywheel oscillator synthesiser chains with micro Hz resolution. He has published a book on 'Fundamentals of RF Circuit Design with Low Noise Oscillators’ (Wiley).
Address:Canada
Agenda
To join the meeting: https://eu.bbcollab.com/guest/6ba4adc680e249ab8aa04fd3df3ce16c
A few friendly reminders:
- When you join, please mute your microphone. You may turn off your camera if you prefer.
- Prof. Everard will answer questions afterwards as time permits.